81.0K
YOTrying out Something new but don't expect this to be a common thing
(Inspired by DangitProductions on YouTube and Instagram)
(Wouldn't recommend this if you're not experienced with figure modification)
Tools Needed:
Hot Water
Dremel
ANSAI Custom Ball Joints
Green Stuff/Apoxi sculpt
Super glue
Strong Blade of some sort
Drill Bit Set
1) Heat The Figure in Hot Water the pop off the legs
2) Make a clean cut between the pelvic swivel and ab crunch
3) Use the Dremel to round the ends of the Abdominal area Start Dremeling a hole where the socket should be.
(If you go too deep or want extra support then use apoxi to keep the socket in place)
4) Dremel and the pelvic area until it looks similar to a MAFEX or G.I. Joe classified look pelvic joint. Try to avoid the center of the pelvic area that's where you're gonna drill the ballpeg so it needs the most plastic for support
5) Once you finish Dremeling the pelvic area use your drill bit to make a hole equal to the size of your ball peg. Place your ball peg into the hole then use the superglue to seal it.
Once you reattach the legs and let everything sit for an hour you should be good
Please be careful Be Save and I hope this helped!
@yourvillaingalliot
