9.5M
K8DIY PUKING SKELETON TUTORIAL 🤮💀 If you want to flex on your whole neighborhood this year 👀
IN BIO:
🔗Supplies linked on my LTK & Amazon
👩🏼🍳‘Cozy Comfort Meals’ recipe ebook
🗞️’Savor n’ Season’ weekly newsletter
SUPPLIES:
-Black trash can
-Drill
-Loctite tite foam
-Fluorescent green spray paint
-Matte clear finish spray paint
-Blacklight acrylic paint
-Paint brush
-3/4 inch clear tubing
-5 ft. skeleton
-Zip ties
-Water pump
-Green Gobbler
-Waterproof blacklight
-Submersible pump
-Blacklight spotlight
DIRECTIONS:
1. Drill a hole in a black trash can big enough for tubing and the plug to fit through.
2. Drill two small holes above the tubing hole to be able to zip tie a blacklight in place that will shine on the “puke” to make it glow.
3. Add spray foam across the top and spray paint it fluorescent green.
4. Paint on ‘TOXIC’ in neon orange blacklight paint.
5. Seal everything in with matte clear finish. This will help keep paint from dripping if it gets wet.
6. Zip tie tubing through skeletons mouth and down spine.
7. Run the other end of the tubing through the hole you drilled earlier in the trash can.
8. Connect the tubing to a water pump and set on the bottom.
9. Secure your skeleton to the trash can by zip tying his arms to the sides.
10. Add in black light facing up to shine on “puke” and secure with zip ties through the small holes in the trash can you made earlier.
11. Add some water and pour in Green Gobbler.
12. Place a blacklight spotlight on the ground shining on the trash can to light everything up.
#diyhalloween #halloweendiy #halloweenprojects #halloweenfun #halloweendecor #halloweenoutdoordecor #halloweenideas #skeleton #pukingskeleton #halloween2025 #halloweenfun #halloweendecorations
@k8lynanderson
